Cliofar 600 SL is a liquid, selective, foliar, systemic herbicide for control against annual deciduous weeds, as well as against bonito, during vegetation for wheat, barley, oats, rye, sugar and fodder beet, cabbage, cauliflower, corn, canola, onions and turnips. Cliofar 600 SL is a pyridine synthetic auxin (group 4) herbicide, and destroys weeds by blocking cell growth in meristematic tissues. Affected plants stop their vegetation for up to a week, are not competitors of the crop, gradually show signs of chlorosis, necrosis and within 5-6 weeks after treatment die completely.

USES OF THE PRODUCT:

• Wheat, barley, oats, rye – preferred use in the early weed phases – ВВСН 21-39 – 17 ml/ 1000 m2 – working solution 20 – 40 l / 1000 m2
• Sugar and fodder beets – preferred use in the early weed phases – BBCH 11-33 – 25 ml/ 1000 m2 – working solution 15 – 40 l / 1000 m2
• Cabbage, cauliflower – preferred use in the early weed phases – BBCH 12-19 – 25 ml/ 1000 m2 – working solution 20 – 40 l / 1000 m2
• Corn for grain – preferred use in the early weed phases – BBCH 13-16 – 17 ml/ 1000 m2 – working solution 20 – 40 l / 1000 m2
• Rapeseed oil – preferred use in the early weed phases – BBCH 12-19 – 25 ml/ 1000 m2 – working solution 20 – 40 l / 1000 m2
• Onions – preferred use in the early weed phases – BBCH 11-14 – 25 ml/ 1000 m2 – working solution 15 – 40 l / 1000 m2
• Turnips – preferred use in the early weed phases – BBCH 12-19 – 25 ml/ 1000 m2 – working solution 20 – 40 l / 1000 m2

APPLICATION: For the best effect, use Cliofar 600 SL during the active period weed growth. They are most sensitive in the initial stages: 2-8th leaf.

PREPARATION OF THE WORKING SOLUTION: Fill the tank halfway with clean water. Stirring, add the required amount of product. Add the tank with the rest of the required amount of water.

GENERAL WARNING
ALL CROPS
Do not use any plant material treated with CLIOPHAR 600 SL for composting or mulching. Do not use manure from animals fed on crops treated with CLIOPHAR 600 SL for composting. A period of at least 125 days must be observed prior to planting of succeeding crops following treatment with CLIOPHAR 600 SL.

ALL CROPS (EXCLUDING CEREALS)

CLIOPHAR 600 SL residues in plant tissues (including manure and digestate) which have not completely decayed may affect succeeding susceptible crops. If treated crop remains have not fully decayed by the time of planting following crops then avoid planting: peas, beans and other legumes; carrots and other umbellifers; potatoes; lettuce and other compositae; glasshouse and protected crops. To avoid risk to field crops following application of CLIOPHAR 600 SL to crops other than cereals, do not plant susceptible autumn-sown crops (e.g. winter beans) in the same year as treatment with CLIOPHAR 600 SL. Where susceptible crops are to be planted in spring, do not apply CLIOPHAR 600 SL later than the end of July of the previous year. Chop and incorporate all treated plant remains in the early autumn (or as soon as possible after harvest) to release any residues into the soil, where they are more quickly broken down. Following good agronomic practice ensure that stubble and straw (including farmyard manure) and other treated plant remains have completely decayed before planting susceptible crops.

CEREALS
Straw from cereals sprayed with CLIOPHAR 600 SL may contain residues which could damage certain crops. To avoid such risk:
Field Crops: Bale and cart away the straw. Where straw is chopped and incorporated do not plant winter beans in the same year as treatment with CLIOPHAR 600 SL.
Glasshouse Crops: Straw from treated crops should not be used or supplied for use as straw in compost, poultry litter, manure or spent mushroom compost for any glasshouse crop.
Straw from treated crops may be used for strawing down strawberries.

NOTES
For best results apply CLIOPHAR 600 SL when the weeds are actively growing.
Control of mayweeds may be reduced if they are suffering from drought stress at the time of application. Control of creeping thistle and other perennial weeds may be impaired by cultivations either before or within a period of two weeks after application of CLIOPHAR 600 SL.
In common with good spraying practice CLIOPHAR 600 SL should not be applied when the crop is damp or when rainfall is expected within six hours.
Do not spray when crops are under stress from cold, drought, pest damage, nutrient deficiency etc. Where 2 applications are made to a crop a 7 day minimum application interval must be observed. Consult processors before using on crops for processing.
Contract agents should be consulted before using on crops grown for seed.
Do not apply to crops undersown with clover or other legume containing mixtures.
CLIOPHAR 600 SL is not subject to vapour drift, but do not spray in windy weather and avoid drift onto susceptible crops (eg seed potatoes).
Take care to avoid drift onto crops and non-target plants outside the target area.
Wash spraying equipment thoroughly with water and a liquid detergent immediately after use. Spray out.
Fill with clean water and leave overnight. Spray out again before storing or using another product, particularly where changing over from herbicides to insecticides. Traces of CLIOPHAR 600 SL can cause harm to susceptible crops (eg seed potatoes) sprayed later.
CLIOPHAR 600SL should be applied in tank mix with other products only if any requirement or restrictions on the other product label do not conflict with the requirements or restrictions of CLIOPHAR 600 SL. Tank mixes should not be allowed to stand in the tank and agitation should be maintained at all times.

MIXING
Fill the spray tank half full with water and add the required amount of CLIOPHAR 600 SL mixing well, then complete filling. If using a tank mix the other products should be mixed with the water first following the label instructions, and CLIOPHAR 600 SL added last. The spray mix must be agitated continuously until application is complete.

SPRAY QUALITY
Apply CLIOPHAR 600 SL as a MEDIUM spray as defined by the BCPC system

CLIOPHAR 600 SL applied in the 0.17 L/ha + 0.33 L/ha programme will also give some suppression of young plants of amphibious bistort (Polygonumamphibium) and colt’s-foot (Tussilagofarfara).

OILSEED RAPE AUTUMN SOWN
OILSEED RAPE
CLIOPHAR 600 SL can be applied to all varieties of autumn sown oilseed rape in the spring from the two fully expanded leaf stage but before the flower buds are visible above the crop canopy.

Perennial Weed Control
For the control of creeping thistle apply CLOPYRALID 600 SL at 0.33 L/ha in 200 litres of water per hectare at the weed rosette stage (up to 30 cm across).

Annual Weed Control
For annual weeds apply CLIOPHAR 600 SL at 0.17 L/ha in the spring. In competitive crops of oilseed rape mayweeds up to 10 cm in diameter will be well controlled by CLIOPHAR 600 SL at 0.17 L/ha. Apply in a water volume of 200 litres/ha.

SPRING SOWN OILSEED RAPE
CLIOPHAR 600 SL can be applied to all varieties of spring sown oilseed rape for the control of annual weeds or creeping thistle. For annual weeds apply CLIOPHAR 600 SL at 0.17 L/ha in 200 litres of water per hectare. For creeping thistle apply CLIOPHAR 600SL at 0.17 L/ha at the rosette stage followed by a second application three to four weeks later of 0.33 L/ha in 200 litres of water per hectare

SUGAR BEET, FODDER BEET AND MANGELS
CONVENTIONAL VOLUMES
For the control of annual weeds apply 0.17 L/Ha in 200 to 250 litres of water per hectare. For the control of creeping thistle apply 0.17 L/ha in 200 to 250 litres of water per hectare at the rosette stage, followed by a second application of 0.33 L/ha in 200 to 250 litres of water per hectare three to four weeks later.

Use Alone
CLIOPHAR 600 SL may be used alone from the fully expanded cotyledon stage of the crop.

LOW DOSE PROGRAMME
Compatibility CLIOPHAR 600 SL at 0.17 L/ha in 80 to 100 litres of water per hectare may be applied as part of the sequential low dose programme with the following products.
CLIOPHAR 600 SL can be included once at any stage of the programme with the other herbicides provided the products are used according to manufacturers’ instructions. To complete control of creeping thistle a second application of CLIOPHAR 600 SL alone at 0.33 L/ha in 200 to 250 litres of water per hectare should be made 3 to 4 weeks later.

CONTROL OF VOLUNTEER POTATO
CLIOPHAR 600 SL, when used for the control of volunteer potato will give good stunting and loss of vigour to the potato. The control of green foliage will not be complete but the reduction in vigour will significantly reduce the competitive threat posed to the crop from this weed. As well as the reduction in vigour there can be a substantial reduction in number and weight of any daughter tubers that are produced. Any daughter tubers that are formed by a potato plant subsequent to the application of CLIOPHAR 600 SL can have reduced viability and loss of vigour.

Timing
The timing application of CLIOPHAR 600 SL is dependent upon the size of the potato. For best results it is recommended that these timings are adhered to.
The first application should be made when the volunteer potato shoots are between 5 and 10 cm tall providing the sugar beet crop is at the sizes stated above. The second application should then be made when the volunteer potato is between 10 and 20 cm tall.
The size of potato for this second application is that of an untreated potato, for an accurate guide to when this stage is reached it is advisable to leave a small area of untreated potato in the field. Typically the second application will be 7 to 14 days after the first.
Applications of CLIOPHAR 600 SL should in all cases be completed before the end of June.
When applying CLIOPHAR 600 SL for the control of volunteer potato the total amount applied to the crop should not exceed 0.33 L/ha (i.e. 2 applications of 0.17 L/ha).